MEP Shark 382-1 SXI EVO – Semi-Automatic Bandsaw Machine

SHARK 382-1 SXI EVO, electrohydraulic semi-automatic band sawing machine to cut metals mitering from -45° to +60°. In addition to the semi-automatic cycle, it can also operate in manual and semi-automatic/dynamic modes.

Capacity: 380 x 250 mm

• Console with all centralized controls, installed on an articulated arm.
• Low voltage soft keyboard, in polyester, with thermo-shaped buttons, with tactile feeling and sound signal when operating.
• Display for the following messages: Diagnostic + Allarms (cause description). + Input and output status. + Cut counting. + Time spent for the cut made. + Blade motor absorption. + Blade tension. + Blade speed. + Numeric displaying of the head position.
• Control handle of the manual cycle at 24 V, IP55.
• Program with several special cutting cycles.
• Latest generation hydraulic control unit, with high efficiency and low energy consumption.
• Rotating table (mounted on a 420 mm roller bearing, pre-loaded with thrust bearing) with steel vice plates which can be replaced after wear.- Double band rotation speed (40/80 m/min) with card PRESET to mount the electronic inverter for the continuous adjustment of the band speed (from 15 to 100 m/min).
• The limits of the head stroke are programmed through the control board, depending on the dimensions of the bars to be cut.
• Sliding vice with sideways movement and fast-positioning system which functions in automatic also when in manual mode.
• Manually-operated blade tensioning through electronic transducer, with displaying.
• Steel base allows to recover coolant also when cutting at the maximum degrees.
• Coolant tank inside the steel base with electric pump so as to lube-refrigerate band. The drawer to collect chips can be replaced with a motorized chip evacuator (see optionals).
• Preset to be equipped with the spray mist system (OPTIONAL), as well as with the standard-delivered traditional lubrication with emulsible oil.
• Wire chip brush for band cleaning.
• Machine arranged for handling with movement equipment.
• Adjustable rod to measure stop to make cuts of the same length with millimetred steel rod.
• Stock support arm with roller predisposed to mount loading table.
• Bi-metal band for solids and sections.
• Service keys and instructions manual for maintenance and spare parts list.